Mercedes Benz EZS EIS ELV ESL Dash Gateway Full Test Cables with OBD W210 W211 W212 W220 W221 W164 W166 W203 W204 W207 W906 W639
New device designed for on-bench testing of EZS (EIS), ESL (ELV).
Comes with ESL Emulator inside, has automatically mode switching - read ESL using and Emulation mode. You can test both old (Motorola based EZS) and new (NEC based) units without the car - just connect them with special set of cables.
Could be purchased in place of old devices: EIS cables set, ESL emulator, W164/166/203/204/207/210/211/212/220/221/639/906 testing cables.
Customers who bought this product also bought:
Smart remote key used in BMW CAS series 1, 3, 5 and 6. It is also valid for X5, X6 y Z4.
Genuine part number: 5121032907, 66126986585
Frequency: 868 Mhz FSK
Transponder PCF 7945
Emergency key blade HU92 included
RKE box si applied at the following aspects:
- When you watnt to use a flip remote instead of a straight one.
- No method or apparatus temporarily to add a new remote control.
- As temporary replacemente when genuine remotes are out of stock.
- When dealer only provides one genuine remote.
- When you want to use a low-cost remote key instead of an expensive genuine remote.
Key blade for old mercedes smartkey flip remotes hu64 HU64
16 other products in the same category:
From the year 1994 most Renault cars are equipped with engine immobilizer system and it makes replacement of injection computer more complicated. There is no problem if replacement ECU is bought from Renault service dealer - it is sold with no immobilizer code stored, but replacing damaged computer with used one is impossible because of mismatch of unlocking codes.
Decoding tool has several modes of operation and deals with all known petrol and diesel injection systems, introduced in range of year 1994-2001 without intervention in to the ECU (diesel coded anti-start valve as well). After decoding process is completed, control unit became de coded - as it was bought from dealer. ECU must be taken out from the car and connected to the decoding tool according to user manual.
Tested System for Renault ECU Decoder:
- Siemens Fenix3
- Siemens Fenix5
- Siemens Sirius32
- Sagem Safir(55pin)
- Sagem Safir2(55pin)
- Bosch Motronic MP7.0
- Magneti Marelli IAW 06R
- Bosch MSA 15.5(DTI)
- BOSCH EDC15C3(DCI)
- LUCAS DCU3R(1.9D)
- Code Fuel Cut-off valve(1.9D DDS)
Decoding of engine control units manufactured in range of year 1994-1996 is semi-automatic, from year 1996 - fully automated. Especially this tool can be useful when rubber-filled FENIX5, SAFIR2 or coded diesel anti-start valve must be decoded. This tool will decode all listed type 1 and 2 immobilizer systems..
Buying this tool you will be supplied with all required information: user manual and connection diagrams. Decoding tool is stand-alone, no PC is required.
The following ECU’s will need a valid immo code:
- Some of FENIX5 for LAGUNA/SAFRANE 2.0l 16V
All of SIRIUS32 except for KANGOO 1.4l 16V - You can attach the immo emulator on this ECU after decoding
LUCAS DCU3R, Bosch MSA15.5 and EDC15C3
This means that after the decoding procedure on one of these ECU is done, you must have the immobilizer system fully operational (matching key) to start the engine.Otherwise after decoding the above ECU’s you can use a Renault emulator
Universal Can Filter blockage KM and Read (some models)
Renault blockage KM in ABS
Laguna 3 blockage KM in ABS
Megane 3 blockage KM in ABS
Scenic blockage KM in ABS
Fluence blockage KM in ABS
W205 (C-klasa) Block synchro EZS-DASH *
W222 (S-klasa) Block synchro EZS-DASH *
W447 (Vito) Block synchro EZS-DASH *
W205 (C-klasa) Block Read orginal Km from EZS by Diag (read from EZS is same as from DashBoard) *
W222 (S-klasa) Block Read orginal Km from EZS by Diag (read from EZS is same as from DashBoard) *
W447 (Vito) Block Read orginal Km from EZS by Diag (read from EZS is same as from DashBoard) *
(*options available from 05.05.2016)
W204 1pcs. Can Filter blockage KM and Read in the ignition
W212 1pcs. Can Filter blockage KM and Read in the ignition
W221 1pcs. Can Filter blockage KM and Read in the ignition
W166 1pcs. Can Filter blockage KM, 2pcs. Can Filter blockage KM and Read in the ignition
W205 1pcs. Can Filter blockage KM, 2pcs. Can Filter blockage KM and Read in the ignition
W222 1pcs. Can Filter blockage KM, 2pcs. Can Filter blockage KM and Read in the ignition
Vito model 2015 1pcs. Can Filter blockage KM, 2psc. Can Filter blockage KM and Read in the ignition
A KLASE model 2015 1pcs. Can Filter blockage KM, 2pcs. Can Filter blockage KM and Read in the ignition
B KLASE model 2015 1pcs. Can Filter blockage KM, 2pcs. Can Filter blockage KM and Read in the ignition
CAS- founded in CAS blockage KM and Read
DashBoard- founded in DashBoard blockage KM
FEM- founded in FEM blockage KM
Remote key programmer CK-100
OBD cable for KD Entry.
With this tool you will be able to get Ford and Mazda PIN Codes. No extra hardware or software is required
You just need to plug the PIN Code Reador to car's OBD2 socket and you will be able to get 4 or 6 digit PIN Codes for most vehicles up to 2014.
It includes 50 free tokens and software updates are free of charge
BMW AK90 Key Programmer for BMW EWS. THE ONLY ONE CAPABLE OF PROGRAMMING EWS2.
It can be used in models between 1995 and 2009 which use EWS system. Improved some of the EWS to read and write speed. This product is safe and effective. Is the key to match the best tool for BMW.
1. Directly reading data dumps from MCU which marked 1D47J , 2D47J , 0D46J ,2L86D without removing MCU from circuit board , easy to do yourself.
2. With the help of software you can renew , lock or unlock keys as well.
3. Programming original chips "EML 10030A" for making keys .
4. Identifying keys for all EWS and CAS , showing VIN , key No. It can change VIN, can change mileage in ews.
The lastest update software version is V3.16 for EWS4.4. Includes EWS2.1/EWS2.2/EWS3/EWS3.3/EWS4/EWS4.4
- 1pc x AK90 Host
- 1pc x AK90 10 Pin Cable
- 1pc x AK90-Chip data to read specific seat
- 1pc x AK90 V3.19 software CD-ROM
- 1pc x AK90 USB communication cable
This device is able to program keys and remotes with Toyota G and H (4D/67/68/72G) transponder chips directly via OBD connection socket. No extra software, hardwares or laptops are required.
It covers all vehicles with G and H chips manufactured by Toyota between 1996 and 2015 when there is no total loss of keys. It only works when we want to add a new key.
The process is easy and fast. You can find attached an users guide that will guide you through the process.
VAG Tacho allows user to read security codes on dashboards, program new keys and modify information.
VAGTacho is used to repair unprogrammed dashboards without diassemble them. You can download all data to a computer and the work on it.
It works with Windows 7, tanto en 32 como en 64 bit.